Two Factor Authentication

Digi-Access™ Authentication

[1] Securing any on line system with usernames and passwords may not offer the level of protection and security your organisation needs.

You can improve the security by adding a 'second layer' of protection called 'two factor authentication [2]'. This means adding another method of authenticating your users, on top of the existing username and password access.

Digi-Access™ adds two security functions:

To ease the introduction of this two factor authentication system into your organisation, Digi-Access™ can be completely managed and outsourced under Total Trust Management™ [TTM™] [3].

And because Digi-Access™ is compatible with 27 different servers [4], adding the second two factor authentication layer of security to your infrastructure does not require any re-programming of your existing environment. It literally 'sits in front' of your current systems.

Two Factor Authentication Demos'

Digi-Access™ no cost implementation [8]

Digi-Access™ Setup & Activation

As there are only three steps, a basic setup of Digi-Access™ should be possible in less than a few hours. The three simple steps are:

1.	If required, change the location of the Login [9] page

2.	Configure [10] the server to use Digi-Access™ certificates for two factor authentication
2.5	Customise [11] the IIS error pages (IIS Only)

3.	Invite [12] users to get their Digi-Access™ Certificate and approve [13] successful applicants

Digi-Access™ Setup Instructions >> [9]

Advice & On Line Buying Options [14]

Digi-Access™ Certificates are issued and managed by the Digi-CA™ [15] Certificate Authority [CA] system. The system can be offered as a managed service (Digi-CA™ Service [16]) from outside your organisation or as installed software (Digi-CA™ Server [17]), depending on your requirements.

More Information >> [18]